Certified Wireless Analysis Professional (CWAP) is the full name of the CWAP-403 exam. Passquestion offers valid CWAP Certification CWAP-403 Practice Test Questions to help you pass your exam easily,if you practice well, you will feel easy to take your CWAP-403 exam.

When you pass the CWAP exam and hold a valid CWNA certification, you earn the CWAP certification and credits towards the CWNE certification should you choose to pursue it.

The Certified Wireless Analysis Professional (CWAP) is responsible for the capture and analysis of data related to wireless networks following troubleshooting principles and methodology. This professional has an in-depth understanding of protocols, frame exchanges and standards at the Physical layer and MAC sublayer. This person is proficient in the use of spectrum and protocol analysis tools.

The following table provides the breakdown of the exam as to the distribution of questions within each knowledge domain

Share part of real CWAP-403 questions and answers in the following:

QUESTION NO: 1
Which one of the following should be the first step when troubleshooting a WLAN issue?
A. Identify capture locations
B. Identify probable causes
C. Perform an initial WLAN scan and see if any obvious issues stand out
D. Define the problem
Answer: D

QUESTION NO: 2
Which one of the best following is an advantage of using display filters instead of capture-time filters?
A. Display filters allow for focused analysis on just the packets of interest
B. Once created display filters are reusable for later captures
C. Display filters only hide the packets from view and the filtered packets can be enabled for view later
D. Multiple display filters can be applied simultaneously
Answer: A

QUESTION NO: 3
Using a portable analyzer you perform a packet capture next to a client STA and you can see that the STA is associated to a BSS. You observe the STA sending packets to the AP and the AP sending packets to the STA. Less the 2% of all packets are retransmissions. You move to capture packets by the AP and, while the retry rate is still very low, you now only see unidirectional traffic from the AP to the client. How do you explain this behavior?
A. There is a transmit power mismatch between the client and the AP and while the client can hear the Aps traffic, the AP cannot hear the client.
B. The portable analyzer has a lower receive sensitivity than the AP and while it can’t capture the packets
from the client STA, the AP can receive them OK.
C. The STA is transmitting data using more spatial streams than the potable analyzer can support
D. The portable analyzer is too close to the AP causing CCI, blinding the AP to the client’s packets
Answer: B

QUESTION NO: 4
Given a protocol analyzer can decrypt WPA2-PSK data packets providing the PSK and SSID are configured in the analyzer software.
When performing packet capture (in a non-FT environment) which frames are required in order for PSK frame decryption to be possible?
A. Authentication
B. Reassociation
C. 4-Way Handshake
D. Probe Response
Answer: C

QUESTION NO: 5
When configuring a long term, forensic packet capture and saving all packets to disk which of the following is not a consideration?
A. Total capture storage space
B. Individual trace file size
C. Real-time packet decodes
D. Analyzer location
Answer: B

QUESTION NO: 6
You are performing a multiple adapter channel aggregation capture to troubleshoot a VoIP roaming problem and would like to measure the roaming time from the last VoIP packet sent on the old AP’s channel to the first VoIP packet sent on the new AP’s channel. Which timing column in the packet view would measure this for you?
A. Delta
B. Absolute
C. Roaming
D. Relative
Answer: C

QUESTION NO: 7
Protocol analyzers may present field values in either binary, decimal or hexadecimal. What precedes a
hexadecimal value to indicate it is hexadecimal?
A. 0x
B. %
C. HEX
D. 16x
Answer: A

QUESTION NO: 8
Which one of the these is the most important in the WLAN troubleshooting methodology among those listed?
A. Interview the network manager about the issues being experienced
B. Talk to the end users about their experiences
C. Observe the problem
D. Obtain detailed knowledge of the wireless vendors debug and logging options
Answer: C

QUESTION NO: 9
The network administrator at ABC Engineering has taken a large packet capture from one of their APs running in monitor mode. She has very little knowledge of 802.11 protocols but would like to use the capture file to evaluate the overall health and performance of their wireless network. When she asks your advice, which tool do you recommend she opens the packet capture file with?
A. Capture visualization tool
B. Protocol analyzer
C. Spectrum analyzer
D. WLAN scanner
Answer: B

QUESTION NO: 10
802.11k Neighbor Requests and Neighbor Reports are sent in what type of Management Frames?
A. RRM
B. Action
C. Beacon
D. Reassociation Request and Reassociation Response
Answer: C