Looking for preparation of NS0-193 NetApp Certified Support Engineer Exam? Passquestion is a website which can help you save time and energy to rapidly and efficiently master the NCSE certification NS0-193 exam related knowledge.You can get the latest NetApp NS0-193 Practice Test Questions to study and we ensure 100% pass NetApp NS0-193 Exam successfully.

NS0-193 Exam Preparation - NetApp Certified Support Engineer

Candidates for NetApp Certified Support Engineer (NCSE) certification should have at least 6 to 12 months of experience with NetApp® solutions and technology, including on-site and remote support, general troubleshooting and root cause isolation, hardware replacement, documentation, node configuration, and software and firmware upgrades.

The NS0-193 exam includes 60 test questions, with an allotted time of 1-1/2 hours to complete. In countries where English is not the native language, candidates for whom English is not their first language will be granted a 30-minute extension to the allotted examination completion time.Your results will be available in CertCenter two (2) to five (5) business days after you complete your exam.

NCSE ONTAP NS0-193 exam includes the following topics:

ONTAP® Fundamentals
Platforms and Storage
Configuration and Troubleshooting
Performance Analysis
NetApp® Data Protection and Management Software

Download NCSE NS0-193 Practice Test Questions:

1.You are setting up a disaster recovery site and have just installed the remote cluster. To communicate between your two locations, you must set up a dedicated network interface on each cluster.
Which role should be used for these interfaces?
A. cluster
B. intercluster
C. cluster-mgmt
D. data
Answer: D

2.What will be the result of adding all nine spare disks to the aggregate?
A. The aggregate will have seven RAID groups.
B. You receive the "maximum number of raidgroups exceeded" error.
C. The aggregate will have three RAID groups.
D. The aggregate will have five RAID groups.
Answer: D

3.Your storage system has experienced a double-disk failure. When is this scenario considered to be in double-degraded mode?
A. when two disks failed in a single RAID group
B. when two disks failed on a single disk shelf
C. when two disks failed on a single aggregate
D. when two disks failed on a node
Answer: A

4.A customer recently had a controller module failure on a FAS62xx system running clustered Data ONTAP 8.3.1.
The controller module had been replaced last night and everything is working well but the customer noticed warnings concerning licensing on the console. The warnings say there is a grace period of 89 days remaining.
In this scenario, what should be done to solve this problem?
A. Obtain new 8.2x format license keys and install them using the appropriate commands.
B. Collect the new license keys from the new controller module packaging and install them using the appropriate commands.
C. Execute a system restore to recover the previous license keys, and then apply to the new controller module.
D. Apply the previously used license keys using the appropriate commands.
Answer: A

5.Which two capabilities does the Flash Cache feature have that the Flash Pool feature does not have? (Choose two.)
A. Flash Cache works for all aggregates assigned to a node.
B. Flash Cache is a read-only cache.
C. Cached data is available and unaffected by takeover events.
D. Compressed blocks are cached.
Answer: AB

6.A customer has a company –wide power outage scheduled and needs to gracefully power off a 2-node cluster. In this scenario, which two steps should be performed? (Choose two.)
A. Use the halt –node –skip-lif-migration-before-shutdown true –inhibit-takeover true command.
B. Use the half –node * command
C. Use OnCommand system Manager to half the controllers.
D. Invoke and AutoSupport message to indicate aplanned maintenance time.
Answer: AD